Chongqing Wolik Environmental Protection Equipment Co., Ltd.
Continuous rotation movement, the rake teeth intercept the solid suspended solids in the sewage. When the retentate is transported to the upper part of the equipment, the rake teeth change the direction of movement, the solid debris falls by itself, and the debris stuck on the rake teeth depends on the rubber brush of the cleaning mechanism Run it in the opposite direction to remove it. When overloaded, the spring is pressed down and the proximity board is close to the proximity switch to stop the motor.
Installation and commissioning
1. The hoisting grille must be hoisted with a steel wire rope to the top hole of the box or the hoist ring.
2. Installation position: The feet of the rotary grille must be flush with the bottom surface, and the front end of the equipment and the front surface of the groove should be basically flush.
3. Fill the anchor bolts with cement mortar. After the cement is completely solidified, tighten the nuts.
4. Before starting, the front of the rotary grille should be free of large stolen items such as large stones.
5 , operation
1 ) Check whether all parts are loose before running.
2 ) Remove the motor cover and turn the fan by hand. The whole machine should run easily and flexibly.
3 ) Lubricate the sprocket and chain with lubricating oil.
4 ) Jog the motor, check whether the running direction is correct, start the motor, check whether the electrical appliances are operating normally and reliably, and the working current is normal.
5 ) During the operation, all parts should rotate flexibly without jamming and abnormal sound.
6. Rotary grille uses elastic device as overload protection. Before use, adjust the close position of the switch.
1. The bearings of this machine are lubricated with calcium-based grease. For continuous operation, open the bearing gland every six months to add enough grease.
2. Chain lubrication: Lubricate the chain and sprocket with lubricating oil once a week.
3. The lubricant of the cycloidal pinwheel reducer should be kept at the normal position of the oil mark for a long time.
4. The motor bearings are changed for lubricating oil every six months.